Where is the spare tire on a Ford Explorer?
The spare tire in your Explorer is mounted beneath the rear of the vehicle, just in front of the rear bumper. The spare is held in place by a retainer and a retainer cable. The Explorer comes from the factory with a special tool to lower the cable and remove the retainer.
Where is the spare TYRE on a Ford Ranger?
Fortunately, accessing and removing the spare tire on a Ford Ranger is fairly simple, despite the fact that the tire is located underneath the bed. Tires are subject to extreme conditions, so they must be in good condition to keep you safe on the road.
How do you get the spare tire off a Ford Ranger?
Rotate the jack handle with the wheel nut wrench counterclockwise to lower the spare tire to the ground. Rotate the tire retainer in the center of the spare tire in a counterclockwise direction until the retainer separates from the tire, then pull the tire from under the truck.
Where is the spare tire on a Ford Transit Connect?
The Ford Transit Connect spare tire tool can be found in the cargo area behind the passenger seat. The cargo area is where You can find the jack kit and the tool to release the spare tire which is housed underneath the back of the van. There is a small opening at the back of the van right at the back door opening.
How do you change a flat tire on a Ford Transit?
Place the replacement wheel on the vehicle and get the lugs hand tight and lower it back down. Finally once it is down torque the lugs down using the tire iron. To change a tire on a ford transit first locate the jack point under the vehicle, raise the vehicle, remove the lug nuts, and then remove the tire.
Where is the jack on a Ford Transit?
The Ford Transit jack can be found in the rear of the car, under the passenger seat. You can access it by sliding the seat forward, and You will see the compartment which holds the jack. It is always recommended to use the jack with the car fully secured in position.
What size Jack do I need for a Ford Ranger?
A 1.5 for small stuff an a 3.5 for the ranger.
Can I put jack stands under rear axle?
Jack stands are the most secure and safe way to raise a vehicle. Always be sure to place jack stands under the control arms, frame crossmember or frame members. If you need to lift all four wheels off the ground for exhaust or transmission work, the rear axle is often the preferred placement for jack stands.