How do you reset the service light on a 2007 Mercedes Sprinter?
2007 Mercedes Sprinter 311 CDI – Service Indicator Reset – This One Works!
- Put the key in the ignition and switch it on without starting the engine.
- Hold the “O” button down till you hear a beep (could take a while, 30 sec.)
How do I unlock my Mercedes radio code?
To obtain your radio code you can:
- Visit your local authorized Mercedes-Benz dealer.
- Contact our Customer Assistance Center with your Vehicle Identification Number (VIN),
- Via phone: at 1-800-FOR-MERCEDES (1-800-367-6372)
How do you remove a Eurovox head unit?
Get a coat hanger, cut a pieces of wire, long enough to be bent and fit into the 2 holes on either side of the head deck, push the wire into the holes and your head deck should then be able to be pulled straight out.
How do you remove a factory radio?
How to Remove a Factory Car Stereo
- Locate the screws that hold the dash plate in place. Then, use the appropriate screwdriver to remove them by turning them counterclockwise until they come out of the holes.
- Remove the stereo bolts.
- Put your hand behind the stereo and grasp the antenna wire.
- Disconnect the power.
How do I change the controls on my VY steering wheel?
Re: Replacing VY Steering Wheel Stereo Controls Disconnect the wiring and remove the airbag. Remove the large nut in the middle of the wheel to remove the steering wheel and unplug the wiring for the controls as you take it off. Remove the old controls and replace them with the new ones then reverse the process.
How do you remove a VY glove box?
Open the glovebox and remove the two travel limiting lugs (11. fnis is done by carefully raising the rubbertabs on the’limiting lugs and pulling them rearwards’ Once pulled reanrrards, gently pull the rubber tabs towards ihe center of the glovebox. To release the glovebox, pull glovebox towards the rear of the vehicle.
How do you get behind the glove box?
Open the glove compartment. Look for stops along the sides or the top of the compartment and undo them. If there is a strut involved, unscrew the end attached to the dashboard. There may be hinges along the bottom that you need to unscrew.