Why is my Pontiac Grand Am not starting?

Why is my Pontiac Grand Am not starting?

While there are a variety of reasons your Pontiac Grand Am won’t start, the most common 3 are a dead battery, an alternator problem, or failed starter.

How do you start a Pontiac Grand Am without a key?

How can I start my car without the ignition key? Remove the screws that are holding the electrical part (the part with the wires) and the mechanical part of the ignition switch together. Insert a flat-head screwdriver into the key hole and turn in the same direction as you would your key . This will start your car .

How do I know the ignition switch is bad?

Signs Of A Faulty Ignition Switch

1. Car Won’t Start. If you turn your key and the car attempts to start, but fails, then you might have a broken ignition switch.
2. Key Won’t Turn.
3. Car Stalls.
4. No Noise From The Starter.
5. Dashboard Lights Flicker.

What happens if ignition switch goes bad?

If the ignition switch fails while the engine is operating it may cut off power to the ignition and fuel systems, which will cause the engine to stall. Depending on the exact issue, the vehicle may or may not be able to be restarted a short while later.

What are the signs of a bad ignition relay?

5 Symptoms of a Bad Ignition Relay

• Ignition is unresponsive.
• Engine stalls.
• Fluctuating Ignition power.
• Dead car battery after night.
• Bad electronic smell.

What happens when starter solenoid goes bad?

Sometimes a bad starter solenoid, instead of preventing the engine from starting, may cause it to start on its own without the key being turned to the “start” position.” This less-common problem can be dangerous and should be addressed immediately.

Can you bypass a starter solenoid?

Place the metal blade of an insulated screwdriver across both metal contacts. This bypasses the solenoid and creates a direct connection between the starter motor and the ignition switch.

Can you fix a starter solenoid?

The starter solenoid turns an electric signal from the ignition key into a high-voltage signal that activates the starter motor. Replacing the starter solenoid with a new starter does not always have to be done. The solenoid lends itself to repair just like any other component, and savings can be realized by doing so.

How do you free a stuck starter motor?

Another method to loosen a stuck gear is to tap the starter with a hard tool, such as a wrench. However, you need to know the location of the starter motor on your car and be able to distinguish it from other parts. When you have located the starter, gently hit it with the hard tool.

How much does it cost to replace starter solenoid?

The cost of rebuild parts for a starter can range from as little as $50 to as much as $350. A brand-new starter can range from $80 to over $350. For a qualified mechanic to replace or rebuild your starter, you can expect to pay between $150 and over $1,100.

What are the signs of a faulty starter motor?

Trouble Ahead: 4 Signs of Starter Motor Failure

• Buzzing Noise. If the engine doesn’t crank but a consistent buzzing sound that occurs when the key is turned, it usually means that there is a flow of electricity to the starter, but the motor is not actuating.
• Loud Clicking.
• Whirring Noise.
• Grinding Sound.

How do you tell if it’s your starter or ignition switch?

Test the Starter It is under the hood, usually on the passenger side at the bottom of the motor next to the transmission. The ignition switch is a set of electrical contacts that activates the starter and usually is located on the steering column.